Hydrotech PURA QCUF Quick Change Ultrafiltration Drinking Wa User Manual download pdf (Page 16)

Step 4 – Install Filter System Assembly

The mounting bracket contains four mounting slots. The holes are sized to accept #10 round head wood screws (supplied).

Some types of surfaces such as particle board or drywall, may require the use of plastic screw anchors or toggle bolts to

provide adequate support for the unit.

1. Tape the paper template included with this unit to the wall with the base of the template on the bottom of the cabinet

(or higher). Be sure to leave adequate space (8 1/2” or more from the centerline) on both sides of the template.

2. Drill 1/8” hole at each location as indicated on the template.

3. Remove template. Thread one of the included wood screws into each hole leaving approximately a 1/2” space

between the screw head and mounting surface.

4. Hang the bracket on the mounting screws. If unit is loose, tighten the screws further.

Install Filter Cartridges

1. Twist the cartridge to lock it into the manifold. (as shown)

Connect System

When cutting plastic tubing, use a sharp utility knife. Cut the tubing squarely. See page 7 for cutting and connecting tubing.

2. Connect 1/4-inch OD white plastic

tubing from the feed water supply

source to the system inlet on the

manifold.

1. Connect quick connect elbows

to the three open connection

locations on the unit. Firmly push

the fittings into place, then pull

back lightly to lock them in.

3. Connect 3/8-inch OD blue plastic

tubing from the product water

faucet to the manifold.



White

Blue

Stage 1

Sediment Filter

Stage 2

Sediment Filter

Stage 3

Ultrafiltration

Membrane

Stage 4

Carbon Block

Filter

Figure 15



12"

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Hydrotech PURA QCUF Quick Change Ultrafiltration Drinking Wa User Manual Page 16