5600SE ValveIron & Sulfur FilterOperation Manual#51404 03/05Read all instructions carefully before operation.
8To determine the frequency of regeneration, use this procedure:Days:Total amount of iron to be removed between regenerations -÷ ppm of iron to be rem
9Manual Regeneration CycleIf you run out of filtered water because of inadequate regeneration frequency, inadequate reserve capacity, power failureor
10The unit is shipped fully tested and assembled and weighs approximately 7 lbs. The feeder assembly includes:10” x 16 “ black tank Black injection mo
11Operating InstructionsSoundsYou will notice new sounds as your filter operates such as the hum of the timer or click of the actuator arm. Duringrege
12PROBLEM CAUSE CORRECTION1. Filter fails to regenerate or A. Electrical service to unit has A. Assure permanent electrical serviceregenerates at wro
13Trouble Shooting Guide Cont’dPROBLEM CAUSE CORRECTION7. Iron filter fails to draw A. Drain line flow control is A. Clean drain line flow controlch
GGUUAARRAANNTTEEEEHYDROTECH guarantees that your new water conditioner is built of quality material and workmanship. When properlyinstal
How Your 5600SE Water Filter WorksYour automatic iron filter is an ingeniously simple and reliable design. The unit consists of a bed of filter media
In normal operation, the Time of Day display will alternate being viewed with the Volume Remaining display. This displaywill be in gallons. As treated
Installation InstructionsAll government codes and regulations governing the installation of these devices must be observed.CAUTION: If the ground from
41. Place the iron filter and the chemical feeder container on a flat surface in desired location, near a drain and 120 volt ACoutlet. Subjecting your
5Operating InstructionsThe valve has been pre-programmed with factory settings as follows:Regeneration Cycle Step Programming1. Backwash ...
6Operating InstructionsWhenever the valve is in Service the current time of day can be set, the control programmed, or an extraregeneration initiated
71. The first option setting display that appears in the Program Mode is Treated Water Capacity. Using theSet Up or Down Buttons, set the amount of tr
Comments to this Manuals