Hydrotech Precision-PWS 12-12 OWNERS GUIDE User Manual download pdf (Page 24)

5. Push the ¼” household feed line fully into the elbow and reinstall the

locking clip between the elbow and collet.

6. Make sure the Control Cable is connected between the water distiller head

and the storage tank by turning the plug until the splines lock and then turn

the locking ring until finger tight. See the Control Cable Connection

Diagram below.

Control Cable Connection Diagram

Boiling Tank Drain Valve Diagram

7. Refer to the Boiling Tank Drain Valve Diagram above. Close the boiling

tank drain ball valve at the rear of the water distiller (ball valve is shown in

the closed position). If the water distiller is equipped with the PWS AED-1

Automatic Electric Drain the ball valve should be in the open position.

8. Tighten the saddle valve handle completely by turning clockwise to pierce

the water supply line (copper or plastic water line only). Open the water

supply to the water distiller by turning the saddle valve handle counter-

clockwise. Check for leaks.

CONTROL CAB LE

WIRES

BOX

TO SEWER

DRAIN ELBOW ASSEMBLY

GEAR CLAMP

TUBE

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 65 66

No comments

Hydrotech Precision-PWS 12-12 OWNERS GUIDE User Manual Page 24