Hydrotech Precision-PWS 12-12 OWNERS GUIDE User Manual download pdf (Page 29)

Overheat Reset Switch – Manual Reset

Fuse – 1 Amp Slow Blow 240V

Storage Tank Drain Valve

- Recessed into the front of the water distiller head front

cover.

- The reset button will shut the unit off if the water

distiller has overheated, it may be rese

t once the water

distiller has cooled off. If the situation continually

repeats itself this may also indicate a problem and

should be looked at by a service center.

- The reset button is a safety feature and is designed to

shut the water distiller down should it overheat.

- Push your finger through the hole in the front cover

labelled ‘Manual Reset’ to reset. A snap will be heard

when the switch is reset and distilling can resume.

- This is a feature to protect the pump option electrical

circuit and is located on the bottom of the water

distiller head at the rear.

- Always replace with the proper fuse.

To enjoy pure water from your water distiller storage tank

use the storage tank drain valve on the front of the storage

tank. The valve handle can be tipped one way to control

the flow of water or tipped over the opposite direction and

locked in the open position to fill large containers. Water

can be pumped automatically to a faucet at the kitchen sink

or other location by installation of an Optional Pump Kit.

See PWS APK-1 Pump Kit and PWS APK-1 Pump Kit

Installation in the Optional Accessories Section for a

diagram of the kit and installation instructions.

STORAGE TANK

SIGHT GAUGE AND

DRAIN VALVE

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 65 66

No comments

Hydrotech Precision-PWS 12-12 OWNERS GUIDE User Manual Page 29